Home > Exhibition > Content
Product Categories

About the lubrication of cut to length line

Wuxi Puxin Machinery Factory | Updated: Jul 03, 2017

For cut to length line itself, if the lubrication performance is not good, it will appear abnormal wear parts early, and if the case is severe and may be scratched or bite phenomenon, it will cause malfunction, and reduce the service life of cut to length line.

2042470998.jpg

steel levelling machine

The clearance of parts of cut to length line new machine assembly is relatively small, because the assembly factors such as lubricating oil (grease) is not easy to form a uniform oil film on the friction surface of it, this will make the lubrication effect is reduced, so in the use of the process should pay attention to lubrication.
In the use of cut to length line of rear guide rod and a screw rod, to determine its weekly lubrication once; for the cut to length line guide, when we in the initial phase of the day must ensure the lubrication time; about the synchronous shaft, worm gear synchronous fork, etc. These exposed wear parts two times a week, lubrication; last words, the lubrication system must be regularly checked, repaired and cleaned.

3开平 .jpg

CNC cut to length line


Wuxi Puxin Machinery Factory
Contact: Peijun Guo
Mob: +86-13951579100
Tel: +86-510-83208381
Fax: +86-510-83209882
Add: 76# Qianluo Load, Huishan District, Wuxi, Jiangsu, China
Email: wxpx0510@163.com
Website: http://www.pxslitter.com

Products
Slitting series
Leveling series
Flat steel series
Coil upender
Contact Us
Tel: +86-510-83208381
Mob: +86-13951579100
Add: 76# Qianluo Load, Huishan District,
Wuxi, Jiangsu, China
Email: wxpx0510@163.com
Feedback