Preheating debugging of vertical shearing machine before starting
By improving cutting quality of slitting machine, improve material utilization, so as to prolong the service life of the machine, we installed in the longitudinal shearing machine, some of which should be checked, in addition, we should also pay attention to check before debugging, should be pre heat, thus preventing the because caused the mechanical damage.
In checking the slitting machine, first of all, we should pay attention to whether the machinery is noisy or not. Second, we need to check that the various parts of the equipment are flexible and normal.
In the slitting machine debugging, we also have to pay attention to matters. When starting the press for continuous stamping, rotate in a clockwise direction, and the speed of the feeder of the slitting machine can be controlled by adjusting screws. If the slider of the slitting machine is moving more slowly, we need to check whether the slider will touch the nylon gasket when it moves back and forth.
Before commissioning, we should check that the feed direction is correct before we turn on the power tester. It should be noted that when the punch speed is constant, the feed distance will need to be shortened from length to length. At this time, we should start up the boot screw up.
Finally, we should adjust the slitting machine rack and slitting machine to the feeder distance, is to consider the punch speed and feeding machine feeding length, make appropriate adjustments to the distance, so you can make the material smoothly into the feeding machine and the mold, the processing is convenient.
Wuxi Puxin Machinery Factory
Contact: Peijun Guo
Add: 76# Qianluo Load, Huishan District, Wuxi, Jiangsu, China