Cut To Length Line
For our production in the use of machinery and equipment, especially the cut to length line, will inevitably appear vibration phenomenon. And the phenomenon of vibration will definitely affect production efficiency. Then, what should we do to avoid the vibration of cut to length lines?
To avoid the vibration of cut to length lines, the main measure we should take is to eliminate the vibration source, and then to stay away from the resonance region. Normally, we need to adjust the operating parameters of each part of the system so that the machine is running away from the natural frequency of the system, so that resonance can be avoided.
For the vibration of the cut to length line, if it is due to the damage of the bearings, we should replace them in time. For all rolls, balance adjustments shall be made. This reduces the vibration source that we use to vibrate the belt conveyor.
Through the research, we found that for the cut to length line in the front of the belt conveyor to increase support components can effectively improve system rigidity. But for the belt conveyor, it has the requirement of lifting and lowering, so the permanent fixing structure can not be adopted. Therefore, we should clamp the hydraulic cylinder and clamp a guide plate fixed on the belt machine body so as to fix it on the upright post of the press. To avoid the vibration of the cut to length line, we need to rely on the clamping force of the hydraulic clamping device to balance.
If you are interested in our products, please contact us!
Wuxi Puxin Machinery Factory
Contact: Peijun Guo
Add: 76# Qianluo Load, Huishan District, Wuxi, Jiangsu, China